
                             Paclink Revision History

New Paclink History listing beginning with release 3.0.0.0

Initial release version 3.0.0.0

   This is a new program that replaces Paclink MP. It requires a fresh installation and
   initialization of parameters.
   
   This a a major update. The primary feature changes are removal of the requirement for
   sysop registration and login password. This program can now be easily run with or without
   access to the Internet for initial configuration.
   
   A number of improvements have been made to speed up user interaction with the program.
   
   The radio drivers have been rewritten to clear up known problems. A driver for the Micom 3F
   radio has been added.
      
   The range and bearing window (if used) now remembers its last location and opens in the 
   last position used.
   
   The IPWorks third-party control used in the program has been updated to version 8.

Release version 3.0.1.0 - November 2, 2008
   
   This release adds the ability to use an RMS Relay telnet port with Paclink in lieu of
   a direct connection to a CMS site.
   
   This also corrects an error in the message routing logic that occasionally caused individual
   addresses in a multiple address message to fail to route properly.
   
   
Release version 3.1.0.0 - Feb 25, 2009

   Initial Alpha test release of extended Paclink. Major changes from 3.0.3.1 include:

	Addition of Native KISS mode TNC support. 
	Addition of WINMOR Virtual TNC and WINMOR Channel support. (Code installed but WINMOR channel menu disabled in this version).
	Autoupdate revised.
	New Help file

Release version 4.1.0.2	Mar 2, 2009
	All updates up to PaclinkW version 900.1.0.2 but without any WINMOR references.

Release version 4.1.0.4 
	Fix of Native KISS DLL to handle proble seen on TNC-X.
	Removal of any WINMOR channels in dropdown connect list.

Release version 4.1.0.6 Mar 21, 2009
	Update of Native KISS DLL.
	Fix of problem not allowing 2 port selection of KAMXL in Packet Channels menu. (unverified!)
	
Release version 4.1.0.7 Mar 25, 2009
	Fix for Packet call not getting set in PTC II.

Release version 4.1.0.8 Mar 265, 2009
	Update of all support documents including PMBO.txt list and help.
	In Packet TNC channel changed default Native KISS .aps file to "ExampleNativeKiss.aps" to match filename.

Release version 4.1.0.12 May 24, 2009
	Update Native KISS TNCs to allow GUI baud rate selection and use either 1200 baud or 9600 baud
	section of .aps file.
	Update Help
	Changed .aps file for TH-D7 to use standard Tasco (was D700)

